[Translators] Howto build an NLS-claws-mail

[Erik P. Olsen]

On 2016-06-09 at 12:48:05 Paul wrote:

> On Thu, 9 Jun 2016 13:23:52 +0200
> "Erik P. Olsen" <epodata at gmail.com> wrote: 
> 
> > Well, claws-mail comes with a configure script and that was the
> > first I ran.   
> 
> The GIT repo does not have a configure script. Are you not using
> the version pulled from GIT?
> 
> > Then I modified configure.ac and ran configure again.
> > Then autogen.sh several times with and without arguments.
> > Apparently da.po wasn't grabbed in any of the runs. I admit I am in
> > a somewhat panic mode because I fail to see the logic in this
> > build.  
> 
> I can't understand what you're doing wrong.
> 
> Add da.po to po/
> Add 'da' to the ALL_LINGUAS line in configure.ac
> rm po/claws-mail.pot
> ./autogen.sh [with configure options]
> make
> sudo make install
> 
> That should be all there is to it.
> Near the beginning of the `make` output you will see it building the
> translations. da.po should be among those.
> 
OK, thanks again. I'll pull claws.git again and do it all over. Perhaps
I had something wrong from the very beginning.

-- 
Erik